[Tom Martinek]

Is there a way to convert a clone image into an “real” image.  I find when I want to fill in a clone with a new in-between, I have to insert and a blank and delete the extra clone to keep my timing the same.  If I could either convert the clone to a real image or swap a new frame for the clone, it would reduce the steps of adding and removing a frame.

[Tom Martinek]

Never mind, I found the “clear drawing” function right AFTER I posted this…..

[Niels]

Hi Tom, Yeah, I was going to tell you about Clear Drawing 🙂 I’m glad you found it 🙂 That’s the one. I always use it from the shortcut, which is *.

Additionally, there’s the O shortcut – which is turning your clone into an Original (ie. loosing its link). This is if you want to keep your drawing and only want to adjust a small part of it.

Cheers,
Niels